Stainless Steel. Sometimes referred to as a "Cage" bit. The side plates or "cages" apply pressure to the sides of the horse's mouth to increase control for the driver against a horse who is lugging. Cob Size (12.5cm/5") Mouth Thickness 15mm
Loops around the bit and lays against the horse's tongue. It is designed to prevent the horse from getting its tongue over the bit.Note: Heat in the sun or warm water to make fitting to tbe bit much easier. Black
Stainless Steel. Loose ring single jointed bit with fixed side bars which sit against the horse's cheek and assist with prevention of lugging.A Mullen Mouth version of this bit is also available.Cob Size (12.5cm/5")Mouth Thickness 15mmRing Size 65mm
Stainless Steel with sweet iron mouthpiece. Recommended for use by professional/experienced drivers for horses that run through or lay on the bit. The cheek pieces attach to the small rings and the reins to the larger rings. As pressure is applied to the reins, the spoons collapse and create jaw pressure but very little mouth pressure Cob Size...
Stainless Steel. The mouthpiece is made up of a series of ball shaped links which has quite a fluid action in the horse's mouth. This also generally promotes mouthing and salivation. This model is excellent for horses who lean on the bit.Cob Size (5"/12.5cm)Mouth Thickness 19mmRing Size 65mm
This model is sometimes referred to as a "JIC Bit". It is designed for strong pullers. The two mouth bars are anchored on opposite sides. Contact on one rein will exert pressure to the lips and corners of the mouth on the opposing side. Used with equal rein pressure, the bit will widen out in the horse's mouth. Stainless Steel Cob Size (5"/12.5cm)
Stainless Steel with Copper wire wrap. Similar in style to the standard jointed mouth overcheck, but with a copper wire wrap across the mouthpiece. The copper encourages salivation and therefore the horse's acceptance of the bit. This bit is suggested for horses with tough mouths. Cob Size (5"/12.5cm) Mouth Thickness 8mm Ring Size 38mm
Stainless Steel. This is a mullen mouth version of the Jointed James bit, so it does not affect palate pressure caused by single jointed bits. Features fixed side bars which sit against the horse's cheek and assist with prevention of lugging. Cob Size (12.5cm/5") Mouth Thickness 11mm Ring Size 65mm
Pullarloop; Make the loop around the lower jaw and connect the rings on both ends along with bit ring with reins.
-diameter 9mm, available in three sizes
Soft rubber-coated nylon, harder than item 5038
Size: S M L